?Like the HP cone crusher seal replacement method

??Used like HP cone crusher of the new and old customers should know - HP cone crusher rack gear grooves of the u-shaped seal, usually there is no contact and wear and tear, but once the seal is damaged in any manner, will be very trouble to change, also important, because the seal is used to prevent leakage and protect the big gear and small gear and bearing of the intrusion of harmful dust on the surface of the precision machining, so the existence of the seal is to protect like HP cone crusher the key to the "heart".

??Even if the seals are damaged, you also don't try so hard. According to the following steps can change like the HP cone crusher seals:

??1, remove the China has damaged seals in the HP cone crusher, and remove residues in any glue sealing groove, and the sharp shovel or a knife to cut off the seal, timely clean up the old adhesive from the slot.

??2, with non oily solvent, acetone or alcohol, thoroughly clean the seal groove, and make it dry.

??3, will die made from a type of seal, before bonding fixed, thoroughly with coarse sand paper burnish seals at the bottom, make its surface brightness. In the manufacturing process to make it easier for packing film, seal coating a layer of remover.

??In order to make the seal glue and well with bonding agent and will seal a strong bond in the main frame of the groove, remover must be cleaned completely. If remover cleaning not clean, not completely during the run, will lead to seal is loose.

??1, is in favor of HP cone crusher seal at the bottom of the coated with a thin layer of curing agent, curing agent must not be blotted out too much, however, because too much can lead to local curing adhesive.

??2, at the bottom of the main frame seal groove with a small amount of curing agent, binder apply it evenly.

??3, coated with adhesive, after the seal as soon as possible into seal groove. Maintain sufficient strength at the bottom of the seal, seal and seal at the bottom of the tank in the contact pressure, bonding process takes about four minutes, make its adhesive completely.

??The above content is like HP cone crusher seal replacement method, the masses of customers if these steps by heart, will surely benefit a lot.