??Italian Replacing HP cone crusher seals

??Italy HP cone crusher used new and old customers should understand that the U-shaped seal on --HP cone crusher rack gear recess, usually no contact and wear, but once the seal is damaged in any way Replace it will be very troublesome, it is also extremely important - because the seal is used to prevent oil spills, protection gear, pinion bearings and precision machined surface of harmful dust intrusion, so there is to protect the seal Italy HP cone crusher "heart" of the key.

??Even if the seal is broken, and we do not worry. Follow these steps to be able to replace the Italian HP cone crusher seal:

??1. Remove China has HP cone crusher in damage to seals and remove any sticky residue in the seal tank, and with a sharp blade or knife to cut off the seal from the groove in time to clean out the old adhesive agent.

??2, with a non-oily solvent, acetone or alcohol, thoroughly clean the seal groove, and allowed to dry.

??3, the mold made of seal type, fixed before the bonding, thorough sanding with coarse sandpaper bottom of the seal to the surface brightness. In the manufacturing process of the seal easier releasing agent may be coated on a release layer, the sealing member.

??In order to make a good seal with the adhesive stick and the strong bond seal groove in the main frame, a release agent must be thoroughly cleaned. If the remover to clean is not clean, it will not lead to complete during operation, seal loose.

??1, in the bottom seal Italy HP cone crusher coated with a thin layer of a curing agent, but the curing agent must not smear too much, because too many words will lead to local curing adhesive.

??2, at the bottom of the main frame of the seal groove Apply a small amount of a curing agent, adhesive coated evenly.

??3, coated with an adhesive, the seal groove sealed as soon as possible. Holding the bottom of the seal has enough power, the seal and the seal groove in the bottom of the pressure contact, the bonding process requires about four minutes to complete bonding.

??The above method is the favorite to replace the HP cone crusher seals, the majority of customers if these steps by heart, will benefit.