Imported oilImported oil rubber seals Specifications Measurement

1. The new import oil rubber seals have under no circumstances use the circular also some differences, so that for the next regular specific measurement conditions. The projector also has its certain degree of error, thus measuring more than 3 times the mean value.

2. The cross-section diameter at home and abroad recognized method of measurement is the projection slice detection, will destroy the product, there will be error detected. So for a particular measurement, measuring rod cone has a higher operating efficiency, accuracy will be more accurate. There is also a simple and practical method for measuring the thickness is measured, this measurement will cause deformation of the O-ring, but also depends on the degree of deformation and the hardness of the rubber itself contact state, the radial and axial diameter of the diameter measurement They are different.

3. The experiments show that the cross-sectional diameter of the measuring time, if you do not consider the temperature of the case. Range 0 ~ 10mm, the measurement error no greater than ± 0.025mm, reading accuracy 0.01mm.

Our ED ring spot stable, 80 degrees to 90 degrees of hardness of the main high pressure are available from stock, other special hardness of 90 degrees for the Division I has the right to build.

ED seals advantage legend

1) complete specifications ED ring, ring size from small ED M08 ~ M60 are available from stock; 2) ED Circle Spot commonly used material for NBR, fluorine rubber;

3) ED Circle hardness with hardness up to 80 to 90 degrees;

4) ED ring Material Division I all choose 100% raw materials imported glue, can you guarantee the quality and stability;

5) ED Circle look no edges, no defects, fine workmanship, cost-effective;

6) ED Circle price we are doing in imported products in the most favorable; ED ring stiffness for the latter part of the installation or use has played a critical role: rubber seals Specifications Measurement

1. The new import oil rubber seals have under no circumstances use the circular also some differences, so that for the next regular specific measurement conditions. The projector also has its certain degree of error, thus measuring more than 3 times the mean value.

2. The cross-section diameter at home and abroad recognized method of measurement is the projection slice detection, will destroy the product, there will be error detected. So for a particular measurement, measuring rod cone has a higher operating efficiency, accuracy will be more accurate. There is also a simple and practical method for measuring the thickness is measured, this measurement will cause deformation of the O-ring, but also depends on the degree of deformation and the hardness of the rubber itself contact state, the radial and axial diameter of the diameter measurement They are different.

3. The experiments show that the cross-sectional diameter of the measuring time, if you do not consider the temperature of the case. Range 0 ~ 10mm, the measurement error no greater than ± 0.025mm, reading accuracy 0.01mm.

Our ED ring spot stable, 80 degrees to 90 degrees of hardness of the main high pressure are available from stock, other special hardness of 90 degrees for the Division I has the right to build.

ED seals advantage legend

1) complete specifications ED ring, ring size from small ED M08 ~ M60 are available from stock; 2) ED Circle Spot commonly used material for NBR, fluorine rubber;

3) ED Circle hardness with hardness up to 80 to 90 degrees;

4) ED ring Material Division I all choose 100% raw materials imported glue, can you guarantee the quality and stability;

5) ED Circle look no edges, no defects, fine workmanship, cost-effective;

6) ED Circle price we are doing in imported products in the most favorable; ED ring stiffness for the latter part of the installation or use has played a critical role: