?Hydraulic compression seal

??The amount of compression of various materials rubber hydraulic seals generally depends mainly on the hardness of the material and hydraulic seals, hydraulic seals if the hardness is 70 degrees, then the amount of compression is equal to 20% of the hydraulic seal.

??That, of course, the lower the hydraulic seal hardness, the greater the amount of compression, mainly used in low pressure areas. So the higher the hardness of hydraulic seals, the smaller the amount of compression, mainly used in high-pressure, pressure, small resistance environments. So, you can get a rubber o-ring compression you need any hardness material.

??Hydraulic seals of different materials, the amount of compression is not the same, the general material NBR nitrile rubber, NR & lt natural rubber, the CR chloroprene rubber, EPDM rubber, EPDM, hydrogenated nitrile rubber of HNBR, SILICOME silicone, SBR styrene butadiene rubber , Buna Buna, acrylate rubber ACM, hydraulic compression seals or 20% is calculated. If special materials FKM, VITON, fluorine rubber, PU, ??FLS fluoro silicone rubber, polyurethane, compression of these materials is based on hydraulic seals 15 per cent.

??These are the compression test values ??of our hydraulic seal, so that businessmen, engineers, reference to a friend, or accurate results you should take to determine the actual assembly of the product. For more information please call.